Bondtech Drive Gear Set, 1.75 mm Filament, 5 mm Shaft
Bondtech / Drive Gear: 1.75 mm / 5 mm
Bondtech drive gear kit in hardened and surface protected steel. Precision cnc-machined. Super sharp teeths for maximum grip on the filament. The perfect choice for a high-performance feeding system. Extremely high wear resistance for use with abrasive filaments. These drivegear kits come as a set consisting of a primary drive gear, a secondary drive gear, bearings and a shaft. Gear set for filament size 1.75 mm, primary gear with inner diameter 5 mm, secondary gear with two needle bearings, M3x2 setscrew and one 3x20 mm shaft. Gear set for filament size 1.75 mm, primary gear with inner diameter 8 mm, secondary gear with integrated needle bearings, M4x3 setscrew and one 4x22 mm shaft. Gear set for filament size 2.85 – 3.0 mm, primary gear with inner diameter 8 mm, secondary gear with integrated needle bearings, M4x3 setscrew and one 4x22 mm shaft. A Lithium based grease is recommended to use on the gear section and inside the needle bearings for low friction and to avoid wear. A small dab of grease is enough.
Bondtech Push-Fit ECAS 4 mm
Push-fit ECAS 4mm is a Bondtech Spare Part to use on the BMG Extruder and on the DDS for CR-10S when a replacement is needed. Size 4 mm is used with 1.75 mm filament.
Bondtech Thumbscrew Assembly
Thumbscrew replacement for Bondtech extruder.
Brass Heat Insert, 5 x 4 mm, M3
Brass heat inserts, specially developed for FDM 3D printed parts and post-insertion.
Inhalt: 100 Stück (0,09 €* / 1 Stück)
Misumi Mobius Drive Shaft, 50 mm, Full D-Cut
Antriebswelle / Länge: 50 mm
Diameter: 5 mm (g6, ground)Length: 50/60 mm (~0.3mm)Roundness: 0.004mmStraightness: 0.1/100Surface roughness: 1.6Surface treatment: black burnished Material: EN 1.1191 equivalent